I’ve been busy getting the CNC Router assembled, aligned, powered, and controlled via software.  After MUCH learning, I was able to have my first trial run today! Using CNC code that produces a 2D ‘sketch’ of the RoadRunner, the Router was run through its paces.  I ran the first couple … Continue reading →

There was a lot of machining and alignment today.  As a result, I now have the X Axis pretty much ready to be tested.  The lead screws, pulleys, timing belt, and motor are in place.  Now all I need is the Stepper Motor driver to run the motor.  The driver … Continue reading →

Today I was able to mount the Y Gantry onto the X Axis tracks and align the tracking bearings.  Happily, the gantry rolls very smoothly, without drag or observable play.

Yesterday was busy, cutting pipes, etc, but not much to show for it.  Today, at least, there is some observable progress with the X Axis tracks and frame in position…

I’ve begun a project to make a new tool – a CNC Router!   This router is based on a design published by David Steel at Solsylva.com.  The unit I’m building is 25 x 25 inch, 3 axis router.   I’ll be posting more soon, but have completed the stand and … Continue reading →