I’ve been busy getting the CNC Router assembled, aligned, powered, and controlled via software.  After MUCH learning, I was able to have my first trial run today! Using CNC code that produces a 2D ‘sketch’ of the RoadRunner, the Router was run through its paces.  I ran the first couple … Continue reading →

There was a lot of machining and alignment today.  As a result, I now have the X Axis pretty much ready to be tested.  The lead screws, pulleys, timing belt, and motor are in place.  Now all I need is the Stepper Motor driver to run the motor.  The driver … Continue reading →

Today I was able to mount the Y Gantry onto the X Axis tracks and align the tracking bearings.  Happily, the gantry rolls very smoothly, without drag or observable play.