I’ve added a new table top to the new Drill Press.  This top is made by Woodpecker and provides a solid fence and T-Tracks for hold downs, stops, and miscellaneous other jigs.  It also expands the width of the original table by about 4 inches and the depth by a couple of inches.  This top should perform well for woodworking projects, especially where there are multiple holes with the same setup or the setup requires complicated jigging.

Note I also aligned the LASER guides that came with the Delta Drill Press.  I originally thought these were too fru-fru and wouldn’t be useful, but, while I was installing the new top, I’d thought I’d, at least, set them up and give them a try.

New Drill Press Table Top. Note the LASER alignment guides. We'll see if those are useful...